trimble 44525-40 gps module use on BMW X5 for sell

accept paypal and ship worldwide

remove from Siemens vod system

50 usd each 

Trimble Resolution T timing gps receiver board for sell

-------------

accept paypal 

ship worldwide 

contrac me for more detals

mokia1985@gmail.com

50 + up in stock.

used,full tested.

-----------

Trimble Resolution™ T Fully Featured, Low Cost, Embedded GPS Timing Receiver Ideal Solution For Mobile Products, Precise Timing When You Need It

		Auto self-survey for timing accuracy Extremely accurate 1-PPS output PPS synchronized to GPS or UTC Cable delay compensation TRAIM assures high PPS Supports 3 V or 5 V Antennas Ideal Motorola FS Encore replacement Datasheet/Manual: Datasheet in PDF format Manual in PDF format

Introduction Trimble's Resolution™ T GPS Timing Receiver is a significant new development in GPS architecture: the general purpose, DSP-based software GPS timing receiver. The development of Trimble DSP/GPS software was key to this accomplishment. Precise Timing Where You Need It The receiver is an all-in-view, 12-channel, parallel-tracking, embeddable GPS receiver designed to provide precise GPS or UTC time and synchronization for many static timing applications. The timing accuracy will provide for your current needs with plenty of headroom for future requirements. This low-cost, yet highly accurate and reliable receiver allows the system integrator to put precise timing and synchronization into locations where cost or size is a limitation. Rather than sharing time from a single timing source, with the resultant delays and loss of accuracy, you now can have precise time (synchronization) at every location regardless of how isolated or remote. Features Flexibility with Software To provide a true software driven GPS timing receiver, the Resolution T receiver uses an off-the-shelf, software programmable, general-purpose, digital signal processor (DSP) in place of the usual custom GPS ASIC. Using a general-purpose DSP allows incremental software improvements to be implemented throughout the product life cycle. This is not possible in custom GPS hardware ASICs, because most features are permanently locked in the hardware design. The Resolution T receiver can be updated easily in the field with new features as they become available. The modular design also allows for both reduced integration time and low implementation risk. 1-PPS within 15 ns The Resolution T receiver outputs a 1 Pulse-per-second (1 PPS) timing signal accurate to within 15 nanoseconds of GPS or UTC (1 sigma) when using an overdetermined solution in a stationary mode. 3 or 5 Volt Antenna Compatible The receiver is designed for 3.3 VDC prime power, but provides a separate pin on the I/O connector for powering the antenna with a user-supplied voltage from 3.0 to 5.5 VDC. Starter Kit The Resolution T Starter Kit provides everything you need to start integrating the module into your application. The kit includes an active, external 5-VDC Bullet-style antenna, 50 feet of RG-59 cable, and an AC/DC power adapter. The starter kit enclosure includes a mother board that provides serial output, and a serial interface cable. A reference manual and monitor programs are provided on CD-ROM.

Specification
Performance:
General:	L1 (1575.42 MHz) Frequency, C/A Code, 12-channel, parallel-tracking receiver, DSP-based
Update rate:	TSIP @ 1 Hz; NMEA @ 1 HZ
Accuracy:	Horizontal Position: <6 meters (50%), <9 meters (90%) Altitude Position: <11 meters (50%), <18 meters (90%) Velocity: 0.06 m/sec PPS: within 15 ns to GPS/UTC (1 Sigma) <5>
Acquisition:	Reacquisition: <2 sec. (90%) Hot Start: <14 sec (50%), <18 sec (90%) Warm Start: <41 sec (50%), <45 sec (90%) Cold Start: <46 sec (50%), <50 sec (90%) Cold start requires no initialization. Warm start implies last position, time and almanac are saved by backup power. Hot start implies ephemeris also saved. Hot and Warm are shown for comparison purposes and are not used in timing applications.
Sensitivity:	Acquisition –136 dBm Tracking –141 dBm
Operational (COCOM) Limits:	Altitude 18,000 m Velocity 515 m/s Either limit may be exceeded, but not both
Interface:
Connectors:	I/O: 8-pin (2x4) 2 mm Male Header RF: Right-angle SMB (SMA optional)
Serial Port:	1 serial port (transmit/receive)
PPS:	3.3 V CMOS-compatible TTL-level pulse, once per second Rising edge of the pulse synchronized with GPS/UTC
Protocols:	TSIP @ 9600 baud, 8 bits NMEA 0183 v3.0 @ 4800 baud, 8 bits
NMEA Messages:	GGA, VTG, GLL, ZDA, GSA, GSV and RMC Messages selectable by TSIP command Selection stored in flash memory
Technical:
Prime power:	+3.3 VDC ±0.3 VDC
Power consumption:	GPS board only: 350 mW @ 3.3 V
Ripple Noise:	50 mV, peak to peak from 1 Hz to 1 MHz
Antenna Fault Protection:	Short-circuit/open detection and protection
Interface Characteristics:
Operating Temperature:	–40° C to +85° C
Storage Temperature:	–55° C to +105° C
Vibration:	0.008 g2/Hz 5 Hz to 20 Hz 0.05 g2/Hz 20 Hz to 100 Hz –3 dB/octave 100 Hz to 900 Hz
Operating Humidity:	5% to 95% R.H. non-condensing, at +60° C
Altitude:	–400 to 18,000 m max
Dimensions:	66.3mm L x 32.1mm W x 8.5mm H (2.6"L x 1.3"W x 0.33"H)
Weight:	12.5 grams (0.4 ounce)
ROHS Status:	This product is lead free/ROHS compliant.

global locate indoor gps receiver

altera unknown adapter with screen

altera PLMG7192-160 adapter for sell

EPM7192E PGA (160-pin)

PLMG7192-160

promice memory emulator for sell

What is PromICE?

Grammar Engine  PromICE began as a memory emulator. By replacing your

target's ROM with its internal RAM memory,  PromICE speeds firmware

testing.  Normally testing new ROM code involves burning an EPROM or

programming a Flash memory, which are time-consuming tasks.  Loading test

code into PromICE emulation memory is fast and convenient.

More than just a memory emulator, PromICE accelerates the debugging process

through a number of features that enhance the capabilities of software-based

debuggers as well as stand-alone debugging.

accept paypal

mokia1985@gmail.com for more detals

http://www.promice.com/support.htm

40 usd.for it

PICSTART Plus development Programmer Microchip Program IC 烧录器

more details

http://www.chipsz.com/ice%20writer%20soket%20chachu/PICSTART%20PLUS.htm

keyence VX-4100 vision sensing system for sell

one for sell.power on ok.no video cable for deep-testing.

accept paypal payment or bank account transfer

ship worldwide.

10 days. by EMS

more details contact me by email

mokia1985@gmail.com

Thank u for looking!.

 

Maxstream xtend-pkg 900mhz RF modem X2

two psc for sell.

sma,

more details please email mokia1985@gmail.com

accept paypal.




You are bidding on a pair of Xstream Wireless 900 MHz RS-232/485 RF Modems. These radios are made by Digi International and have the part number X09-019PKI-R. These radios as a default are set at 19200 baud but can be changed. These radios each include a rubber ducky antennae and an AC-DC power adapter. These radios are in excellent condition and are guaranteed. We used them for a very short time and later switched the application to a different technology. I paid over $500 for this pair of radios. See more information at http://www.digi.com/products/wireless/xstream.jsp

According to Digi's website:

Digi’s XStream-PKG RF modems can be configured in minutes to provide low-cost serial cable replacement between all types of electronic devices. XStream-PKG modems provide transmission ranges of up to 20 miles in a low-cost wireless solution. The modems are coupled with a DIP-switchable RS-232/422/485 interface board and regularly outperform more expensive RF modems.

Their outstanding receiver sensitivity enable XStream-PKG modems to yield two- to eight-times the range of competing modems, allowing customers to cover more ground with fewer devices. Additionally, XStream-PKG modems are easy to use, thereby reducing the complexity of data system development.

XStream-PKG modems can wirelessly connect a variety of devices across many applications including remote monitoring, building automation/security, industrial automation/SCADA, fleet management/asset tracking and sensor data capture in embedded systems.